Difference between revisions of "Sprint Pre 2"

From WebOS Internals
Jump to navigation Jump to search
m (Reverted edits by Foster (talk) to last revision by NuttyBunny)
Line 59: Line 59:
 
<span id="Step_16"></span>
 
<span id="Step_16"></span>
 
Follow the instructions on [[WebOS_2_Upgrade]] and use the ./scripts/meta-sprint-franken-unlocked-pre2-2.1.0 script.
 
Follow the instructions on [[WebOS_2_Upgrade]] and use the ./scripts/meta-sprint-franken-unlocked-pre2-2.1.0 script.
Also you may visit http://www.[http://www.superiorpapers.com/custom_essay.php essays]-internals.org/
 

Revision as of 23:24, 20 September 2011

This is the page where we document the complete Sprint Pre 2 procedure, hardware and software.

Hardware

Rich Dunbar has created a very detailed step by step pictorial guide for swapping a Sprint Pre- comms board into a Pre 2. Important note that the Sprint Comm board must be activated PRIOR to this process. Cannot activate a Sprint Comm board through the Pre 2 at this time. You should also have already read through and understand the entire software portion (Step 16 in this guide) BEFORE starting this process. Pay special attention to Step 2: Prepare Your Palm Profile.


Step 1 - Introduction

Slide1.PNG

Step 2

Slide2.PNG

Step 3

Slide3.PNG

Step 4

Slide4.PNG

Step 5

Slide5.PNG

Step 6

Slide6.PNG

Step 7

Slide7.PNG

Step 8

Slide8.PNG

Step 9

Slide9.PNG

Step 10

Slide10.PNG

Step 11

Slide11.PNG

Step 12

Slide12.PNG

Step 13

Slide13.PNG

Step 14

Slide14.PNG YOU HAVE TO BE EXTRA CAREFUL WITH THE VOLUME ROCKER RIBBON AS IT WILL BREAK IF NOT ALIGNED PROPERLY

Step 15

Slide15.PNG

Software

Step 16

Follow the instructions on WebOS_2_Upgrade and use the ./scripts/meta-sprint-franken-unlocked-pre2-2.1.0 script.