Difference between revisions of "Veer Disassembly"
Jump to navigation
Jump to search
| Line 21: | Line 21: | ||
[[Image:Veer_04.jpg]] | [[Image:Veer_04.jpg]] | ||
| − | == Further separate the backplate at the bottom of the phone == | + | == Further separate the backplate at the bottom of the phone and along the sides == |
Do not pull it any further apart than this. | Do not pull it any further apart than this. | ||
[[Image:Veer_05.jpg]] | [[Image:Veer_05.jpg]] | ||
| − | |||
| − | |||
| − | |||
[[Image:Veer_06.jpg]] | [[Image:Veer_06.jpg]] | ||
[[Image:Veer_07.jpg]] | [[Image:Veer_07.jpg]] | ||
Revision as of 03:17, 28 May 2011
How to disassemble a HP Veer
Copyright Notice: All images on this page are copyright by Rod Whitby, with all rights reserved.
If you wish to use any of these images in any way, you must place the following request for donation and PayPal button immediately adjacent to your use of the images:
An off-contract device was purchased at full price by Rod Whitby for use in this tear-down. To recoup that cost, your PayPal donation is requested. <paypal></paypal>
Further pictures of the internals of the Veer (including high resolution shots of the circuit boards) will be added to this page as sufficient donations are received.
The phone before disassembly starts
Unhook the backplate around the keyboard
Separate the plastic around the bottom of the keyboard and the sides of the phone using your fingernail or a spudger.
Further separate the backplate at the bottom of the phone and along the sides
Do not pull it any further apart than this.
Unhook the backplate along the top of the phone
Do not separate the backplate any further than shown here
